Fosmon Low Voltage Mounting Bracket (1 Gang, 5 Pack), Low Voltage Box, Single Gang Wall Plate, Multipurpose Drywall Mounting Wall Plate Bracket for Electrical Box, HDMI, Coaxial, Speaker, Cables

New house and projects. I bought a pack to keep around so i wouldnt have to go to Lowes as much.These are handy. Actually a friend had a pack and i decided to buy some because of that. I havent figured out an easy way to mark them and then cut the holes. I use the back against the wall and trace it (inside part).But once the hole is cut and i flip it around i have to adjust the hole for the top and bottom parts that stick out and the sides.But overall its been fine for low voltage stuff (running audio cables, network cables, etc)

I needed to install AV openings for my new man-wall. Glad I found these. I cut the hole based on this, and used an AV cover over it to hide the inside of the wall. Who knew a little gizmo like this could make me so happy.

Got this to add a box for an Ethernet jack panel. Worked great, fits snug and solid. I had to trim the wall a bit but that's not hard to do if you have a small hand saw or construction knife. Will be using more of these in the future.

I did not include a photo because all you would see is a wall plate. I still have one to install and maybe I could get a shot before buttoning it up. They are a bit delicate, but so much easier than installing a box! I will tell you be very careful to NOT cut the hole too big. I did (top to bottom) and the plastic just fell through. I took a popsicle stick and chopped off two pieces about three inches (with my big wire cutters). I slipped one under the top lip and bottom lip then gently tightened the bracket until it would not move. Do not over tighten, or it will break. THIS IS NOT FOR AC POWER. These are for audio, video cables etc..

Buena calidad y buen precio

The low voltage old work mounting brackets from Home Depot and Lowes have the clamp tabs at the corners. These have them closer to the center. They mount more securely.

Keep in mind, depending on your faceplate, it may not flush against your wall. My only complaint. But where my item is placed in the room, it won’t even be noticed.

I bought these to go with some speaker terminal plates and they work fantastically. I had used a 2 gang metal bracket in the past and it was terrible because it used folding pieces that didn't clamp on the wall very well so it wiggled. I bought the same style as these in the double gang form so when I needed single I found this set and love them as well. They clamp tightly to the wall so nothing moves and are very easy to install and remove. The only complaint that I have is the screws for the piece that clamps to the wall is a little longer than I would want. When clamped to the wall the screws go into my insulation, however, if they were short enough the plastic piece that clamps to the wall would probably fall behind the wall so obviously I'm not complaining too much. Definitely do not hesitate to buy these things, they are wonderful.

Used along with double gang brush plate to hide tv cables behind wall. Would use again.

Produce designed for stud walls but can be used easily on solid walls

Very useful

Makes installing wall plates a breeze.

Halt eine Montageplatte, wie man sie zu jedem üblichen 220 V Unterputzschalter kostenfrei mitbekommt, hier aber extra für teuer Geld erstehen muss. Was klar fehlt ist ein passender Unterputzkasten! Möglich, dass diese Montageplatte in irgendeinen Unterputzkasten nach anglo-amerikanischer Zoll-Norm passt, bei uns in D finde ich keinen passenden Kasten dafür. Also, wenn man die Platte nicht in eine Hohlwand setzen kann, bleibt nur eine Trageplatte aus Holz, Kunststoff o.ä. dafür schnitzen und die über einen Unterputzkasten schrauben. Nicht optimal und viel Arbeit!