Amico24 Pack Goof Rings for 6 Inch Recessed Lights White Can Light Goof Trim Ring, Outer Diameter 8.6-inch, Inner Diameter 6.2-inch, Durable Plastic Design, Flush Mount

If you have installed canless lights into older can light holes, you know these are a life saver. There are so many different styles of can light fixtures and they can vary in original size of the opening. These are now a staple in my work trailer. The look is clean after installing too. Almost looks like part of the light. However....While these are great, they only fit perfectly for about half of the style canless lights we install. Some of the canless lights have small mounting screw bumpouts around the edge and can interfere with these mounting flat. I have found I need to modify the inter part of the ring to make them fit. Usually what I do is make one and use it as a template for the remaining. Its much easier to modify these rings than it is to repair drywall.

This product is awesome.Ordered this for my 15 recessed 6" Amico lights purchased prior.This was for a retrofit and the holes were slightly off.Rather than have a contractor fix it for a hefty price I opted for this under $30 relatively inexpensive and sleek quick fix.Results are awesome and actually accentuate the lights and make them look that much more expensive than they really are.5 stars ⭐️ ⭐️⭐️⭐️⭐️

Worked great to cover existing holes of older can lights.

These work well in hiding imperfect ceiling lights. No one can tell there's any imperfections at a glance. Highly recommend for ill fitted ceiling lights

I chose these cause they were thinner than another brands. A couple of the rings had jagged edges from a bad cut. They are thinner but a little flimsy. Only an issue if the hole you’re covering isn’t on a completely flat area of the ceiling. Overall, they worked well. I actually like the look with the ring better.

I purchased these to fix issues with the can less light install in vinyl soffit. Covered the gaps and look great!

This is too soft, it deforms easily with the weight of the light spring will start lifting. The hole is not even that big just a small gap so I decided to put on a ring to make it perfectly sealed.

Im replacing the cans in our house with newer flat LEDs lights, and unfortunately have a couple of can lights that had the holes cut too large. These worked great to extend the diameter of the trim enough to cover the gaps. You can see the visible gap in my photo. They're flexiblenand thin, but still worked well enough for me, even over popcorn ceiling.I only wish they can in smaller packs for smaller applications (I only needed 2 for the small section of my home with oversized holes).