YaeCCC 60W 40KHz Ultrasonic Cleaning Transducer Cleaner + Power Driver Board 110V AC

It is the same Ultrasonic set up you find in the small L setups for sale. I am planning on using it in a Stainless Sink from a recycle place and mounting it in the drain. Should be enough adapter options out there to make it work. So far I am happy with the purchase and after the build I can update if there is any problems. I don't foresee that though.Quick shipping and I think a company that will back there product from order to delivery.... Look online how not to ruin these boards dry and blow them. It needs to be mounted and working with a substrate/liquid.

Great customer service. Works great!

I think the people who made this don't know what they're doing (see pics). The cone ran to about 307°F AND CLIMBING (280°F in my picture), and the lead wires to the cone from the PCB got so hot that the solder on the terminal at the cone melted and a wire fell off!! A large resistor on the board also runs way too hot..at about 240°F. I mounted the cone to an SS tube for some work I'm doing, and placed it in about 1 pint of water; I did see a few (but not many!) of the cavitation bubbles, BUT, a piece of aluminum left in the water for 2 minutes did not form any holes. Also, a dirty stone placed in the water did not clean quickly at all (compared to an ultrasonic tank I have), though did show signs of cleaning at about 10% or less the level I am used to seeing. This could be because I did not fasten the cone to the vessel, but instead have it mounted to a stir rod. I did experiment with holding the top of the cone vs not holding it at all, and also with placing the vessel on foam so it could more easily vibrate, although I do think the key is to mechanically fasten/bond the cone to the vessel, or to mount a plate on the end of the "stir" rod.Personally, I would not buy this one again if I could find another supplier that I thought the parts were actually different.MFGR: what needs to change: increased wattage on your 0.25ohm resistor, or run more in parallels. Decrease power to the cone. Increase gauge of lead wires to the cone from the PCB.I'm going to try to power the entire apparatus from a variac to see if I can just run it at a lower energy level.

The thread on the transducer is an M10x1.0.

I am surprise that amazon carries this product. Immediately upon applying 110 VAC it blew up. There is no clear wiring as to where the neutral and power line is to be connected. Essentially this should be taken off until the company provide proper details of the product.I will contact the company again with the hope they can remedy the problem.

pretty good

Absolute junk. There Chinese to English translation is terrible! No help in getting a wiring diagram.

Powerful