Prescott Plastics 2.5" Inch Square Plastic Hole Plugs Insert (4 Pack), Heavy Duty Black Hardware Plugs and End Caps for Metal Tubing, Fence, Glide Insert for Pipe Post, Chair Legs and Furniture Legs

Glides smoothly on carpet. Easy to attach. Snug fit. Excited to find a replacement for the part lost during moving.

Easy to install

When I bought my folding travel carrier for my wheelchair, one of the things that bothered me is having the open holes in the tubing to allow them to rust even further. These plugs fit perfectly into the carrier and tubing (the smaller tubes) with minimal tapping with a rubber mallet.So far they’ve held up well without any chipping, cracking or splitting. And if they do, they will low cost enough that I have extras from the initial package to replace them with. I am satisfied with purchase and would recommend these for anybody looking to close gaps or use them on small tables, or whatever else they might fit into.

Every box tube of a specific outside and inside size is a little different. These were too tight so I used a small fine tooth saw to trim off one side of the fins. Good press fit with a small wood block and hammet to tap and seat the cap.

Pounded these in with a hammer and a block of wood to get them set. Really solid good quality!

Item was packaged well and arrived in a timely manner. Item was used to replace square end tubing caps on my Craftsman mechanics floor creeper. Item works well and as advertised.

We have a Parsons table from Room & Board; these fit the legs perfectly and we added a felt pad to keep our wood floor from getting scratched. The key with these plastic end caps is to get the gauge/thickness of the metal measured and buy the feet with the right thickness of fins for a snug fit. There's usually an option for 10-14 gauge or 14-20 gauge (higher numbers are thinner steel).

These are just the right size. Tight fit and look good. Lost 1/2 of the ones that were installed on my utility trailer, but these have a nice snug fit. I didn't need all of them, but i doubt i will lose and to a loose fit.

They look great and fit perfectly

Fit in the ends of my home made roof racks. (1 inch by 1 inch by 1/8 in steel tubing).

It fit perfectly in the legs of my outdoor patio chairs. It replaced the ends that were broken.

Va parfaitement sur mes chaises et impossible d en acheter ailleurs

Worked well.