Original Sealing Ring for 8 Qt Power Pressure Cooker - Replacement Silicone Gasket Seal Rings for Power Cooker XL 8 Quart, PPC772, PPC780, WAL3, PPC-XL 8Qt, Wolfgang Puck 8 Qt

I noticed the reviews that said the silicon gaskets don't fit, but, I told myself since my exact model is listed as a fit, then I'll be OK. Like other reviewers mentioned......it's too big. I have MODEL PPC772. I left my pressure cooker to build pressure for 40 minutes and came back to it to see it blowing steam all around the lid and leaking water all over the counter. I turned it off. Took the lid off and checked the ring. It was still too loose. For some odd reason I decided to take it off wash it again but put it back on and noticed it fit tighter. I put only water in my pressure cooker to see what would happen. Well, it built pressure and sealed. I think maybe because the way its packaged it may help to run it first time with just water. Let it get nice and hot. Then let it cool. It seemed to tighten up and all the bends in it from being wrapped up by a rubber band were all gone. It was a more rounded shape like it should have been.It is a definite noticeable upgrade in quality than what originally came with my cooker.I think if you notice yours seem to be a little loose when putting on, just leave it on and run the cooker with just water, letting the ring get nice and hot to reshape. Let it cool and then try cooking with it. It certainly made mine fit after I got it hot then cooled, then tried it again.

I bought a cheep one the first time. the reviews were good. I never could get it to seal. Ordered this one made by the company it worked perfect. Nice to have my pot up and running again

I ordered it 2 months ago, didn’t use my power XL until the past week. The ring is slightly bigger than the original, won’t create pressure. I’m outside of the return window, and I have already disposed the original ring. Now my pressure cooker can’t be used.

If you follow the right process it works for the PPC780; unfortunately the process is not documented so here is what I did to make it work.1) I installed the Sealing Ring on the lid and then I added to the PPC780 2 cups of water.2) Turned it on and waited until it started to leak steam around the lid.3) Turned it off and without removing the lid I let it cool down. This step is critical, if you remove the lid you will need to start again.4) Once it cooled down I turned it on again and this time it didn't leak and is working since then.My best theory is that the heat and the pressure while it cools down is required for the ring to actually sit in the right place around the lid and provide the required sealing.I hope these instructions could be added to the product page or the packaging. It will make for a much easier installation experience.

Had to watch some videos online, but be patient, had to heat up and cool down several times for it to seal properly but this does work. Saved me $100's by.not having to buy a whole new pressure cooker.

Replacement gasket fit perfect with my power pressure cooker, XL. I definitely recommend And would buy again

I bought these seals for my 8qt Power XL pressure cooker. They do not work. They are too big for the 8 qt which is advertised. They do not seal the lid which results in a lot of frustration and cursing. Don't waste your money. Now I have to buy more seals some where else.

Works well.

nice to have a proper seal works great

C’est parfait pour mon autocuiseur POWER PPC772