10 x Push to Open Drawer Damper Door Closing System 45 mm Push Pull System with Screw Fasteners Push to Open Magnetic Latch for Door Cupboards Cabinets Cabinets, Grey

I used these to make some workbench 'pop-up' dogs (from a Youtube video) and they work perfectly.

Fitted these to cabinets in my garage they work well and I have to taken off all my handles which now gives a flush finish.

Does the job I had them for.

I bought these to have some handless doors for my wardrobe, and while they work there are two things that you need to note before buying- They’re not every strong. One of the doors is slightly larger than the others and it struggles to push the door open, I may have to add another one but still not sure. At the moment have to open the door next to it to then open the door manually.- They’re wider than 10.5mm. I used a 10.5mm drill bit and they did not fit, which then resulted it not such a seamless finish. I would recommend using and 11mm drill bit.I mean you get what you pay for, if you want something a bit strong and sturdy, I would suggest avoiding these.

don't buy the cheap!, these are worth the extra £2

Fitted to a range of kitchen cabinet doors and drawers. Positives ;- strong latching action, magnetic effect holds the door closed but can be easily overcome if required. Negatives ;- will not fit into a 10mm hole as the fitting instructions state. The internal locking mechanism affects the shape of the plastic casing so it is not round and is nearer 12mm in diameter. Any pressure applied to the casing if forced into an undersize hole will adversely affect the latching action. An oversize hole will require the use of glue to retain the mechanism in position.Fitted carefully into the correctly sized hole , this mechanism works well and is fit for purpose.

Even with an 11mm drill bit these need a whack to get in the hole and then cease to work. Look elsewhere. Once in the hole they are now an unhelpful decoration on my cabinet.

I bought these because of the travel distance and ability to place in a drilled hole (12mm). I wanted them to make some pop up dogs for my woodworking bench and have been able to reduce their compressed length to approx 4.5 cm which suits my need perfectly. Even have some left over so may even get to use them for their intended purpose!!!