DPP Titanium Rear Sight Mount/Mounting Plate Compatible with Glock ModelsIt has one of the lowest bore axes in the industry without any alterations on your pistol. Remove the rear sight on your firearm and replace it with our mount in order to mount your Red Dot Sight. You can take our mount off and replace your rear sight at any time. Installation hardware and tools included(304 Stainless Steel Anti Flicker sealing plate included).0.13"saddle height. One-Piece Design, Lightweight. This provides a steady sturdy and rugged mount that will hold your zero, We focus on improving every detail. Compatible with:  9mm model: 17、19、26、34、45 .357 model: 31、32、33  .40  model: 22、23、24、27、35 .45 Auto model: 21、30、36、41 .45 G.A.P model: 37、38、39 10mm AUTO model: 20、29Not fit all mos modelCompatible with Red Dot Sights (Mounting Screws INCLUDED): Trijicon RMR/SROHolosun 407C/507C&508TInstallation Instructions:Remove the rear sightSlide mount plate into rear sight dovetail *May need press or rubber hammerTighten dovetail socket set screwsPlace the red dot sight on mount plate then tighten the mount screws
D**E
Functional, durable, dependable, ease of installment.
I served in the infantry, in both branches of our military. I run Trijicon ACOGS on a M-4 and an AR-10. I wanted to run a Trijicon RMR on one of my Glock’s, in this case a Model 21 .45 Cal. I wanted to do so without spending money to buy a MOS slide or machine the original slide. Something functional, durable and dependable. I’ve run 250-300 rounds through it and no issues with zero or accuracy. For the reasons I chose this, and the results thereafter, I highly recommend.
L**S
easy install on my Glock 26
this is a do it your self-upgrade. 3 minute instal for my Holosun 407c onto my Glock 26. I pressed out the nylon rear sight with a screwdriver and hammer easy peazy. Slid this kit in place and was off to the range!
B**N
easy to install and sturdy
Got this for mounting Trijicon RMR on my Glock19. It is easy to install and you don't need any extra tools. The mount holds the Trijicon securely. Good choice if you do not want to deal with having your slide milled.
R**K
Great product
This fit my glock 30sf perfectly. I also mounted a Holosun HE507C.Great product.
T**B
Very cost effective way to experience a red dot pistol
Very snug fit. Mounted a Holosun 508 on it but haven’t used it yet due to a flickering/intermittent off red dot. The mount is nice though 👍🏼
K**S
Great secure mount to aviation a slide cut
Fit was tight going on my G19 . Can’t be timid pounding it in place with a polymer hammer. I went with the titanium mount.
K**S
Great product! As expected, a professional should install this.
Great products! I did need to go to an expert to remove my back iron site and center everything properly. However, that's only because I didn't own the right tools and it was cheaper to pay someone to do it than by the tools. Remember, if you don't have a bore sight, you're going to need to go to a Smith anyway.
R**A
Works as advertised
Works well for a temporary optic mount if you are on the fence about sending your slide in to have it milled for a red dot optic. Make sure you clean the drill hole burrs off before mounting otherwise you will scratch your slide!
Trustpilot
1 week ago
1 month ago
