Fluke Networks JR-ERGOHANDLE JackRapid Ergonomic Handle

Good product

If you want to reduce labor cost and speed up termination, this is the way to go. I bought these blade heads to work specifically with panduit net key jacks. Great item

I much prefer Leviton jacks, and have both the cat5e and cat 6 tools for them, but a job with WAY too many Ortronics jacks came along, so I got this- my buddy, whom I was helping, was blown away by the performance of this tool. Highly recommended for any one who has to terminate more than the occasional jack. The ease of use, and the amount of time saved, more than compensates for the nominal cost of the tool.

I have used this tool for a few years now. One of the pins was bent so I replaced this part. Now it works great again.

Haven't actually had to use it yet. Bought the JR-LEV-2 punch down for a large retermination project. Bought the extra cutter in case we needed it. The JR-LEV-2 cut our time down by at least 2/3's. Fluke is always "proud" (expensive) of their products, but it was well worth the investment. It was a bid job and we saved mucho time and money.

This tool reduces terminating time by 60%. Clean cuts!

This is my second Jack Rapid. Great when doing large quantities of jacks. Speeds the process, less wear and tear on the wrist and no punch slippage.Only complaint is the price is a bit high.

Very good