Quick sense 180` Wall-Mount PIR Motion Switch with Light, Energy Saving Sensor Lux Adjustment Set of 2

I marvel how far technology has come that for about Rs 500 any DIY person can implement fairly decent and accurate motion sensing devices. I have many of these (including ceiling ones) at home. Found the wall mounted ones are especially suitable for entrances etc.Attached photo is taken from my bedroom. The sensor is at a height of about 1.8 meter and is at cross angles to the door. Put some black tape to cover part of it so that it is not switched on for every tiny movement inside the room. Works perfectly.Have used "GM 2-Pin Flexible Wire" which is a batten holder, 5 m of wire and a 2 pin plug, by splitting into two and adding a bulb.

Product arrived in good packing, installation guide was perfect, working as per expected. I ordered 2 piece both working fine. Value for money advantage of this product you can light multiple items on single PIR, need to adjust as per your requirements but if you adjust it at little height your area of cover will be less than lower height. Sensor setting working good.

Till date I am not been able to install this Quick sense 180, sensor.I have tried 2/3 electricians to come and fix it, also took this sensor to electrical shop to get it wired. they took were not able to fix it.the diagram is not clear.... Hence its waste of money and energy.There are some other better products...my advice go for those.I hope I can get a refund for this product.

Sensor is accurate.. require trials to adjust expected lux and time.I installed in staircases and bathrooms.. works well.. Overall excellent product.Cons:Adjusting range is a bit challengingKnobs are very fragile..

The motion detection is good and does the job perfectly.In fact, I had to restrict the angle using a black insulation tape to reduce the angle as it is very sensitive for good distance.Bought two pieces. Installed only one yet. Hope the other also works well.