Oil Catch Can Kit with 4 Adapters + Breather Filter Drain Valve Plug 2 Ports (1 oulet + 1 inlet) 150ml Universal Aluminum Baffled Oil Reservoir Tank Oil Separator HTRACING (Red)

I bought this for my husband, and he loves it—the ease of installation. The look and fit of this made a great value for money, the tank quality is perfect for his truck.

Having replaced the intake manifold that was heavily clogged with PCV blow-by oil (after 125K miles), I was determined to add a catch can into the PCV circuit. The Gen 3 Prius is notorious for PCV oil buildup in the intake manifold (Gen 3 added EGR, whose hot gases cook the oil into a tarry residue).See photo for the mounting position attached to inner right front fender. Like other reviewers, I did not use the breather filter; I installed the plug on the top of the can. I made sure all hose clamps were secure, and I have not had any vacuum leak problems (i.e. no CEL error codes).I live in cold Minnesota. In the winter the catch can accumulated mostly condensed water (mixed with creamy oily goo). I established a winter routine to empty the can once a week. I ran a silicone drain hose down to a specific point in front of the passenger side wheel, where I could place a drain pan on the garage floor.In these warmer months, the drainage shows no water, just a small amount of oil (which would otherwise have ended up in the intake manifold). The volume is modest, and I can empty it every 2-3 weeks to stay safe.Product does exactly what I needed at a very modest cost.

Good quality from first impressions. Quite easy to install but so far haven't had it on long enough to really catch much. Going on a 2013 Equinox with the notoriously bad 2.4L Direct Injection engine. BTW if you have this engine, get a venting oil cap as well (https://www.amazon.com/dp/B000C9S2J0?ref=ppx_yo2ov_dt_b_fed_asin_title). These two inexpensive things will save you in the long run.

Quality product. Nice fit and finish. Parts go together nicely.*worth noting - the input and output fittings are shown on the ad opposite from the actual product. This may or not matter for your application.

I received exactly what was advertised.

Have not opened the package or use this product yet.

If you have a GDI engine you should get this, this will reduce the gunk on the intake valves and help you out the endurance of your engine, dont buy expensive ones, this will do exactly the same job.

Super simple design. This is working to catch oil blowby on my worn out 350 engine. Im swapping engines so this is just a bandaide for now. I might put them on the new engine cause they look cool.