Intermatic FD60MWC 60-Minute Spring Loaded Wall Timer, White

This is my third Intermatic spring timer. More expensive than other brands but very reliable

Sturdy & reliable timer

Had one of this exact model in a previous residence and it worked for over 20 years. I have every expectation that this one will continue working for that long and likely both will work until the entire system is replaced for other reasons. This timer is simple to install (about ten minutes of actual install work) and simple to use (just turn the dial). If you need a timer that is really accurate, you may need to look into a digital one, since this relies on a spring and no amount of factory calibration will make it that accurate through its entire range, and make it stay that way for decades. I am using this strictly for DC continuity control.What this does provide is a no-power, no-"smart" switch that works right every time, doesn't need your wifi password, doesn't need a subscription, doesn't lose its marbles if you have a power outage, doesn't send your data and usage habits to an aggregator... on and on.I installed this in a junction box, even though in this application it only provides continuity for 24VDC to control a furnace fan. The spring tension also would tend to twist it out of drywall if it were not adequately secured, so a J-box is a good plan. It may also be required per local code; if you're in doubt, check yours before completing your installation.

Our bathroom timer finally gave out after eight years of use, after checking the big box stores all I could find were the digital timers.After doing some reviews on these digital timer they seem to have a short lifespan. Found the lntermatic spring wound timer here on amazon and it’s the exact same replacement for the one I have. I give this timer five stars for ease of installation and use. Time will tell if it last as long as my old one.

Easy to connect. I am using it as a timer for my gas fireplace replacing a standard wall switch. Be aware that you may need to enlarge any faceplate that goes around it, as the ones I had did not fit, and I had to dremel one. Otherwise works great.