6 mm Baltic Birch Plywood 1/4 x 12 x 24 Inch, Box of 6 B/BB Grade Craft Wood, Stronger Than Basswood Sheets, for Laser, CNC Cutting and Wood Burning, by Woodpeckers

Good strong wood. Didn’t have any boards with warping. I was able to build a pull out shelf with edges for my cabinet using some small nails, clamps, and wood glue and it’s held up quite well.

the edges were straight, reducing the number of cuts I needed to make. the ply is solid and creates nice pieces for my games using a scrolling saw.

I use birch quite a bit with laser projects. This is the only birch plywood that allows you to sand to removed laser residue and doesn't start going into the ply. Highly recommend for anyone with laser projects.

I make laser pics and this plywood does a awesome job

I use a lot of Baltic birch for scrollsaw work. I am used to find some patches in my plywood. This is not a problem for me because I can either work around it on two sided projects, or put the patch on the back, unseen, side of the project. When my order arrived, I inspected each board for defects. to my surprise, I found no patch on any piece. The only flaw that I could find were several pieces with very small knots, which I could use as accent points or place on the back of the project.In short, this is just what I have come to expect from Baltic birch plywood. When you combine the high quality of the wood with the fact that my package arrived the next day after I ordered it, I would say this is an excellent source for ordering plywood.

Perfectly flat Baltic Birch Plywood. No knots and all edges are pristine. Both sides are fine. Fast delivery at a reasonable price. I will buy from this seller again.

Overall its a nice project board for the price. I bought the 4 pack and each one has at least one side free from knots or imperfections in the wood. 2 Out of the 4 had both sides free from knots. Its birch veneer is pretty smooth and does not need much sanding to make it glassy. When used with my scroll saw the veneer does splinter a bit if its fed too fast, not the most stable veneer but by far not the worst. When run in the laser it cuts very clean. I have not tried laser engraving it since none of my projects has called for it yet. I will buy more boards from this seller again. They arrived quickly and undamaged.

Great for my purposes. I had a leak under my sink and had been nervous about getting someone in to replace the warped wood underneath because of Covid. I didn't want to go to hardware store either and get someone to cut a piece for me also because of covid. I rdered this and was able to make small cuts with a jig saw and shimmy 2 pieces inside and lay them right on top of the old piece that was now warped. 8 had planned on dry fitting then cutting him "for real" on the other 2 pieces but didn't need to, they looked fine. Cleaned up the saw dust, now done! Plus I have 2 pieces left over.