OHLPRO3M VHB Sticky Adhesive Pads Replacement for Magnetic Phone Car Mount - Dashboard Sticker With 16MM Ball Diameter

Thank goodness I found this replacement vent clip!! The vent on newer lexus are kinda wide so most clips will not work. The double locking feature definitely helps for sure.

Great vent clip, much better than the hook. But be careful you get the correct size ball as some phone holders have different sizes.

The adhesive is just bad. I had it in my car. There is not sun most of the days. I park in an underground parking garage and it is already peeling off my dash. Don't get it as it is a waste of money.

had to replace due to switching cars

I've bought 5 of these in total for my work's truck fleet and 1 from the original OHLPRO magsafe charger I purchased. Out of the 6, 2 of them had air pockets/bubbles in the adhesive before tearing off. I'm not sure if the actual 3M foam was bubbled up or not, but it did affect the ability for them to stick on. So expect about a third of these that you buy to end up as duds or defects especially if you have a strong magnet setup which will put stress on the adhesive.The 3M vHB material is great and mount is great on the ones that did work flawlessly. The adhesive cover may be a bit difficult to remove since there is no crease or handle. You will have to prep the surface super well, like clean with soap/wipes and make sure its completely dry. Any bit of dirt will ruin the adhesion and waste a mount, especially the ones that have slightly defective adhesives(they can still work and be salvaged if applied properly, i was able to save 1 out of the 2 and use it).My only gripe is that their warranty service on their webpage did not respond to my warranty request, so you are most likely out of luck with defectives and have to go through Amazon's return system.They make a great product, but seem to lack the customer service that ESR and other brands have.

I just purchased this. Attached to my dash on Wednesday when I arrived. Today (Saturday) the sticker has been coming off. They need a better adhesive. But the mount itself works for charger.

Exactly what I needed. Super sturdy and holds well.

The customer service has been exceptionally helpful by ensuring you were happy with your purchase. I had an issue with my mount but after reaching out to the team they were able to fix it right away! Therefore, I would highly recommend this seller. Thank you.