HARLEY DAVIDSON PRE-WIRED THROTTLE BODY 6 PIN CONTROL ACTUATOR CONNECTOR PLUG (33471-0601)

Wire colors matched my stock harnesss making install a breeze! Make sure to get some extra solder heat shrinks in case u mess one up like I did. There’s only enough for the amount u need

Everything fit and plug locked into the female side like it is supposed to. Plenty of extra wire I had to extend mine the stress of it being to short is what caused my problems. The pre soldered but splices made it all nice and tidy.

If you and thinking of purchasing this, you figured out that this silly little connector can cause a world of issues. One thing to consider, this does not have gold plated connectors so the "fretting" issue could happen again, but probably way down the road. Ride hard. - TT418A service bulletin

My 08 Ultra quit for the second time with all the usual codes. I installed this part and everything worked again. The original Harley harness is really a little short and the wires seem stressed. This fix alleviates that. Just pull up a pic of the Harley wiring diagram as the factory wires are 16ga and the colors are fading.

Easy install and worked as described. Everything included to securely connect the wires. This addressed the limp mode issue.

Spliced this harness in to replace my last throttle body connector. Great kit, as you only need a lighter to melt the solder that is already Pulitzer into the shrink wrap. Just cut your existing harness, write down the order of the wire colors, and slice this one in. 20 minute fix.

Throttle response is perfect, thanks!