2 Packs Metal Stair Step Stringers, 2 Step Steel Riser Stringer for 19.4inch Height Deck(Polished Black)

I buried the bottom step because not needed. The provided bolts and bit were spot on. Using a 10X2 board and the above, makes it extremely sturdy. Would buy again!

Painted well, correct size only the top brace was bent a little during shipping.

I attached them to my 4×8 deck on my fifth wheel. Nice and sturdy. Didn't use the provided screws for the 2×12 steps, drilled and used stainless carriage bolts.

I used two kits (4 stringers) to open up my back porch. Hardest part was the concrete bolts. Make sure you take the sleeve off and test fit before to tap it in. Dust packs in the bottom of the holes and stops the bolt short. I found it easier to install stringer on pavers, then level and bolt to porch. I used 2”x12”x16’ and they fit great. The screws did work. I pre-drilled very small holes and hand started. I used and ratchet, 1/4 socket ,and Phillips head bit (tapped in) to tighten. Was an one day project and made a big impact.

Easiest steps to install and great quality!

Seller was prompt and the quality of these stairs didn't disappoint. However we didn't like the instructions and just drilled our screws from the top. So far all is well and these steps have been tested severely!

Overall a wonderful product. Had a bit of difficulty locating a more efficient wrench to get into tight places to screw the nuts onto the bolts to attach the wooden planks to the stringers, but we are happy with the finished product.

Added trex decking with Carrige head bolts to hold down boards. I will buy again if need more step stringers.