Junction Box, Zulkit Project Box IP65 Waterproof Outdoor Box ABS Plastic Electrical Boxes Electronic Enclosure Black 3.94 x 2.68 x 1.97 inch (100X68X50mm) (Pack of 2)

I use these to build battery boxes for my trail cameras. Work great and they keep the batteries and wiring dry and secure.

I'd take off 1/2 Star since you have to install the gasket and it isn't a continuous gasket, but the box is sturdy for being plastic, has stainless screws, and is offered at a decent price. I will buy more. I'm using one box to mount a buck converter, on/off switch, and 9vdc power jack with a battery converter mounted on top for a Milwaukee Fuel battery. It provides ample, clean power for guitar pedals. The batteries last many gigs before needing a recharge, it's easy to carry a spare battery and it eliminates searching for a 117vac outlet, ground loops and having another power cord on the stage. Use a daisy chain, plug and play, excellent clean power and far less expensive than the regulated, filtered power supplies they try to sell you. FYI, you can do the same with a DeWalt battery adapter, or any other. You'll need this box, the battery adapter (they come with on/off switches and fuses), a buck converter and a DC out jack. Tools; a drill and bits, screws to mount the battery adapter, a soldering iron with solder, and a multi-meter to set the buck converter voltage. Not difficult to do.

Works well, seems to seal well

Good quality box, good price.

used this to house a small ESP-based microcontroller and relay for a lighting project. gasket fits well and makes a solid seal. i drilled a hole to accommodate some wiring though and it was easy enough to drill with a standard bit. be aware the inner dimensions are not perfectly rectangular due to the screw holes in each corner. sturdy, solid construction.

Worked great for a project I had.

I’m using these for outdoor work boxes for low voltage switches. The boxes are sealed and use a gasket under the front plate. The mounting holes are through the edge of the box and do not allow water in.All that’s necessary to mount switches and wire glands is a step bit.The box is well made and available in several different sizes. The only improvement to the design would be a slightly larger opening for the mounting holes. I needed to use special small head finishing screws to mount the boxes.

I used this project box to enclose and mount a 3-3/8" digital GPS gauge on an older UTV. The exterior finish, quality and stainless hardware are perfect for the application. Highly recommend!